Click images for larger
Fan Shroud
Beginning of engine stand
Stock ignition w/marks
Valve lapping with hot glue
preheat bolt and valve with
propane torch, use tubing
and drill after cooled.
Legal
Requirements for Use of this Website
All information, parts, and/or procedures developed by this project and
or displayed on this website are subject to your own personal analysis
and acceptance in consideration of your specific needs.
Your use of any of this project information, parts, and/or procedures, is subject to your agreement that you have evaluated this information, parts, and/or procedures, that you have the capacity to make such technical evaluation, and that you have determined that this information, parts, and/or procedures will meet your specific needs and safety requirements.
Use of any information, parts, and/or procedures, stipulates that you and executors of your estate agree to hold all persons and entities associated with this project harmless for any personal or financial loss resulting from use of same.
You also agree that any deviation from this project's information and/or procedures, will most likely increase the chance for failure of your particular application.
You further agree that any use of this project's information, parts, and/or procedures will enjoy unlimited personal use, but will not be used for commercial purposes without express written permission from the founder of this project, Lynn W. Graves.
contact Lynn and let him know what you would like to contribute.
Return to top of page. Return to HomePage
Copyright
© 2009 by Lynn W. Graves
Reproduction or republication for commercial use
prohibited without express written permission
See website rules for further legal information
Website owned and operated by Lynn W. Graves.
Last updated (29Dec08
), lynn@whatifdyno.com